Components
This is DB25 male type connector with facility to solder wires on inner side.The DB25 (originally DE-25) connector is an analog 25-pin plug of the D-Subminiature connector family (D-Sub or Sub-D).As with the DB9 connector, the DB25 is mainly used for serial connections, allowing for the asynchronous..
Rs. 40.00
DB9 Female Connector (Wire type)
Description
This is DB9 Female type connector with facility to solder wires on inner side for making serial cables as per your customized connections.
The DB9 (originally DE-9) connector is an analog 9-pin plug of the D-Subminiature connector family (D-Sub ..
Rs. 12.00
New
DB9 Female Right Angle Connector - 9 Pin - PCB Mount..
Rs. 15.00
DB9 connectors were once very common on PCs and servers. DB9 connectors are designed to work with the EIA/TIA 232 serial interface standard, which determined the function of all nine pins as a standard, so that multiple companies could design them into their products. DB9 conne..
Rs. 12.00
Discontinued
The X9C103 are digitally controlled (XDCP) potentiometers. Dc3v-5v X9c103s Digital Potentiometer consists of a resistor array, wiper switches, a control section, and non-volatile memory. The wiper position is controlled by a three-wire interface. The potentiometer is implemented by a resistor array ..
Rs. 150.00
Hot
DC power jack/connector.
This is a common barrel-type power jack for DC wall supplies. These are compatible with our DC wall supplies and have a 5mm jack, with a 2.1mm center pole diameter...
Rs. 10.00
This is standard 2.1 mm DC power plug/jack. Threaded plastic cap, and wires can be soldered and crimped for longer life. ..
Rs. 20.00
DC Power Jack - Female Connector with 2 pin Screw Terminal
If you need to connect a DC power wall wart to a board that doesn't have a DC jack - this adapter will come in very handy! There is a 2.1mm DC jack on one end, and a screw terminal block on the other. The terminals are labeled with positive..
Rs. 25.00
New
This is DC-DC 4.5-40V To 5V 2A USB Charger Step down Converter Voltmeter Module, a combo of 2A Charger and voltage checker.The module converts input of 4.5-40V into a very stable 5V 2A output. The device features a USB port through which you can charge your phone. While charging your device please c..
Rs. 245.00
The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to g..
Rs. 120.00
Hot
Diffused Green 5mm LED (Pack of 25)Need some indicators? We are big fans of these diffused green LEDs, in fact we use them exclusively in our kits. They are fairly bright so they can be seen in daytime, and from any angle. They go easily into a breadboard and will add that extra zing to your project..
Rs. 25.00