This is a programmer for 89 series microcontroller devices in 20 & 40 pin packages and supports various 8 pin serial EEPROM ICs. ZIF socket enables easy insertion and removal of devices for programming. Programming is very fast since it is USB based.No external power required since it is powered..
Features:
It can be used for programming AVRISP USBASP STK500 10PIN Standard interfaces to standard 6PIN interface converter
It can be used for AVR MCU development board interface converter download
..
The PICKIT 2, Logic-Power, is a low cost development tool with an easy to use interface for programming and debugging Microchip's flash families of microcontrollers. The full featured Windows programming interface supports baseline (PIC10F, PIC12F5xx, PIC16F5xx), midrange (PIC12F6xx, PIC16F), PI..
The PICKIT 3 allows programming and debugging of PIC and dsPIC Flash microcontrollers using a powerful graphical user interface of MPLAB & MPLABX IDE. The Microchip's PICKIT 3 connects to the design engineer's PC using high-speed USB interface and can be connected to the target usi..
ST Link V2 Programmer For STM8 and STM32 is fully consistent with the official version, support for automatic upgrades, support the full range STM32 SWD (only 4pins including SWCLK, SWDIO, and power) and a full range STM8 SWIM (only 4pins including SWIM, Reset and power) download and debug.
Use thi..
ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.
STM8 applicati..
These AVR programmers are based on Thomas Fischl's USBasp design and connect to your computer's USB port. Not only are they quite compact (70x20mm), but the design is really elegant. The USB interface is achieved by using an atmega8 processor and the rest is done in firmware.
Being an Open s..