Menu
Your Cart

Green A4988 Stepper Motor Driver

Green A4988 Stepper Motor Driver
Green A4988 Stepper Motor Driver
Green A4988 Stepper Motor Driver
Green A4988 Stepper Motor Driver
Green A4988 Stepper Motor Driver
GST Invoice
GST Invoice for Input Tax Credit.
Bulk Order
If your required quantity is more than listed below or for Bulk Orders/Quotes, please ping us for lead times & to pre-order.
Rs. 165.20
Ex Tax: Rs. 140.00
  • Stock: 3
  • Model: A4988
  • SKU: PL-665
This breakout board for Allegro’s A4988 microstepping bipolar stepper motor driver features adjustable current limiting, over-current and over-temperature protection, and five different microstep resolutions (down to 1/16-step). It operates from 8 V to 35 V and can deliver up to approximately 1 A per phase without a heat sink or forced air flow.
This product is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection; we therefore recommend careful reading of the A4988 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control onebipolar stepper motor at up to 2 A output current per coil (see the Power Dissipation Considerations section below for more information).
 
 

Here are some of the driver’s key features:

  • Simple step and direction control interface
  • Five different step resolutions: full-step, half-step, quarter-step, eighth-step, and sixteenth-step
  • Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
  • Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
  • Over-temperature thermal shutdown, under-voltage lockout, and crossover-current protection
  • Short-to-ground and shorted-load protection.
 

Dimensions

  • Size: 0.6? × 0.8?
  • Weight: 1.3 g1


General specifications

  • Minimum operating voltage: 8 V
  • Maximum operating voltage: 35 V
  • Continuous current per phase: 1 A2
  • Maximum current per phase: 2 A3
  • Minimum logic voltage: 3 V
  • Maximum logic voltage: 5.5 V
  • Microstep resolutions: full, 1/2, 1/4, 1/8, and 1/16
  • Reverse voltage protection?: N
  • Bulk packaged: N
  • Header pins soldered: N4
 

Write a review

Note: HTML is not translated!
Bad Good