Sensors
Specification:
Onboard precision micro current transformer
Onboard sampling resistor
The module can measure AC currents less than 5A, the corresponding analog output 5A/5mA
PCB board size: 18.3 (mm) x17 (mm)
..
Rs. 195.00
This is a small but very effective Linear current sensor module, This sensor module is based on ACS712 hall-effect based linear current sensor chip. This module is good for max 20A current measurement. ACS712 chip takes AC or DC voltage at its input and its output varies linearly with sensed current..
Rs. 160.00
The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to g..
Rs. 120.00
AM2302 humidity-sensitive capacitance digital temperature and humidity module is a have already calibrated digital composite signal output of the temperature and humidity sensor.It dedicated digital module acquisition technology and the temperature and humidity sensor technology, ensure that the pro..
Rs. 395.00
DHT11 – Humidity and Temperature Sensor for Arduino and Raspberry Pi B/B+/Raspberry Pi 2.
The four-pin device uses a 1-wire protocol. It’s a snap to connect to your project, requiring VCC, GND, and a pull-up resistor on the single data line. We’ve already seen it used on at least ..
Rs. 95.00
DHT22 (AM2302) – Humidity and Temperature Sensor is a low cost humidity and temperature sensor with a single wire digital interface. The sensor is calibrated and doesn't require extra components so you can get right to measuring relative humidity and temperature.Features:3.3-5V Input1-1.5mA mea..
Rs. 345.00
The DS1621 Digital Thermometer and Thermostat provides 9-bit temperature readings, which indicate the temperature of the device. The thermal alarm output, TOUT is active when the temperature of the device exceeds a user-defined temperature TH. The output remains active until the temperature drops be..
Rs. 195.00
DS18B20is 1-wire digital temperature sensor from Maxim IC suitable with 9 to12 bit precision over the range of operation (-55°C to 125°C) .
With an accuracy of ±0.5°C over the range of -10°C to +85° and multiple data logging of temperature spread in wide area network, con..
Rs. 145.00
This is a sealed (waterproof) and pre-wired digital temperature probe, based on DS18B20, 1-wire digital temperature sensor from Maxim IC, providing data in degree Centigrade with 9 to12 bit precision over the range of operation (-55C to 125C). This probe lets you precisely measure temperatures in we..
Rs. 130.00
New
Out Of Stock
Dual Channel Pwm Generator Module to generate square wave for experiment development.This is used to drive stepping motor driver’s square wave, Generate adjustable pulse for MCU using, Generate adjustable pulse for controlling relative circuit .
Features Of 2 channel PWM Generator Module :
..
Rs. 275.00
Sharp's GP2Y1010AU0F is an optical air quality sensor, designed to sense dust particles. An infrared emitting diode and a phototransistor are diagonally arranged into this device, to allow it to detect the reflected light of dust in air. It is especially effective in detecting very fine particles li..
Rs. 450.00
Discontinued
This is an EKG/EMG shield which allows Arduino like boards to capture Electrocardiography Electromiography signals. The shield opens new possibilities to experiment with bio feedback. You can monitor your heartbeat and log your pulse, recognize gestures by monitoring and analize the muscule activity..
Rs. 2,800.00