Wireless & IoT
The SM0038 can almost receive all IR transmitter with 38kHz signals. The outputs can be easily decode by Arduino.
Features
Build-in amplifier and IR receiver
Build-in PCM filter
Low power consumption..
Rs. 25.00
Discontinued
Description:
Remote ON/OFF–Turn electrical devices on/off from anywhere
App Support –Free iOS and Android mobile App eWeLink
Sync Status–Real-time device status provided to App
Timing–Set scheduled/countdown/loop timers to turn on/off at specified time
S..
Rs. 490.00
New
Out Of Stock
The TTGO T-Beam is a powerful ESP32 & LoRa Development Module with GPS onboard and battery charging circuit (for 18650).
Product Features:
ESP32
Lastest ESP32 Version: REV1
WiFi
Bluetooth
4MB PSRAM
4MB Flash
3D Antenna
LoRa Features:
Working voltage: 1.8~3.7v
Acceptab..
Rs. 2,650.00
New
Out Of Stock
This is a custom ESP32 (ESP-WROVER-B 8MB PSRAM) based development board with an onboard 2G/GPRS Module SIM800L. The USB Type C pluggable board also has an onboard LiPo Battery Charging Circuit & Connector and is a good choice for building IoT applications.
Features:
Hardware Sp..
Rs. 2,350.00
Ublox NEO-6M GPS Module with active Antenna is a cost effective, high-performance u-blox 6 based NEO-6 series of GPS modules, that brings the high performance of the u-blox 6 positioning engine to the miniature NEO form factor.
These receivers combine a high level of integration capability with flex..
Rs. 550.00
Out Of Stock
Overview:
WiFi Kit 8 is a cost-effective Internet of Things development board developed by HelTec Automation. The board contains the popular ESP8266 processor, 4MB Flash Memory, a CP2014 IC for USB to Serial Conversion, Lithium Battery Interface and Charge & Discharge circuit, on board WiFi Ant..
Rs. 1,095.00
This 5V-3.3V VCC Adapter Board for NRF24L01 Wireless Module enables you to use NRF24l01 type transceivers on 5V systems like Arduino.
It regulates the 5V input to 1.9~3.6V DC and incorporates bypass capacitors for reliable operation. The NRF24L01 utilizes Enhanced ShockBurst (ESB) protocol to suppo..
Rs. 95.00
![Xbee Explorer Board [FT232RL]](https://potentiallabs.com/cart/image/cache/catalog/Miscellaneous/xbee_explorer-250x250h.png "Xbee Explorer Board [FT232RL]")
XBee Base Board USB interfacing board (Breakout Board) [xbee module not included]
XBee Adapter is a compact USB to serial adapter equipped with BEE (20pin 2.0mm) sockets. With integrated FT232RL IC, It can be used for programming or communicating with board which basic Arduino but without USB inter..
Rs. 320.00
Discontinued
This is the series 2 ZigBee protocol 1mW with wire antenna. Its good for point-to-point, multipoint and mesh networks. This module is a little more difficult to get going than the Series 1 - you must set up a "coordinator" module so they are not as plug-and-play. We suggest this module for those who..
Rs. 1,095.00
Out Of Stock
XBee modules are small RF (radio frequency) devices that transmit and receive data over the air using radio signals. Wireless capability is essential whenever you want to place sensors where no cables can be installed, or where such tethering is undesirable. XBee devices are highly configurable and ..
Rs. 1,995.00
Discontinued
Zigbee Mesh Networking, 2.4 GHz Point-to-point, point-to-multipoint, & peer-to-peer, DSSS (Direct Sequence Spread Spectrum), Channel Capacity 16, 10-bit ADC inputs.Application IdeasRemotely Monitor and Control Wind TurbinesNetwork-Enable Wireless Access Control PointsReduce Hotels' Energy CostsW..
Rs. 1,995.00
Discontinued
This is the XBee XB24-Z7WIT-004 module from Digi. Series 2 improves on the power output and data protocol. Series 2 modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. These modules allow a very reliable and simple communication between microcontrollers, comp..
Rs. 950.00