RCWL-0516 Microwave Radar Sensor

This is a mini radar motion sensor module is equipped with RCWL-9196 chip based on the doppler microwave induction technology.

Product Details:

• Detection Distance    5-9m

• Transmitting Power    20mW (typical); 30mW (max)

• Storage Temperature    -40~100 celsius

• Output Voltage Driving Capacity    100mA

• Output Voltage    3.2-3.4V

• Output Control Low Level    0V

• Output Control High Level    3.3V

• Operating Voltage    4-28V

• Operating Temperature    20~80 celsius

• Operating Current    2.8mA (typical); 3mA (max)

Features

• Equipped with RCWL-9196 chip supporting 4-28V wide voltage input, high level signal output when detecting the motion with active repeat trigger

• 360 degree no blind angle detection with 5-7m deteciting distance, the detection not affected by the surroundings, better performance than the IR sensor

• Support night detecting function turn on /off, adjustable repeat trigger time and detecting distance by add the SMD components to the corresponding pins

• Working Voltage: DC 4-28V, Board Size: 35.9 X 17.3mm/1.41 X 0.68inch

Specifications

• Operating Voltage: 4-28V

• Operating Current: 2.8mA (typical); 3mA (max)

• Detection Distance: 5-9m

• Transmitting Power: 20mW (typical); 30mW (max)

• Output Voltage: 3.2-3.4V

• Output Voltage Driving Capacity: 100mA

• Trigger Way: repeat trigger

• Output Control Low Level: 0V

• Output Control High Level: 3.3V

• Operating Temperature: -20~80 celsius

• Storage Temperature: -40~100 celsius

Adjustment Part Introduction:

• C-TM Adjust repeat trigger time,default trigger time is 2s;increasing capacitor's capacity will make repeat trigger time longer;and actual counting trigger time can operate as below: Stick capacitor on C-TM,test 9196 3-pin frequency F,repeat trigger time T=(1/f)*32768

• R-GN Detection distance adjustment;connect with resistor and detection distance will become shorter;if not connect,detection distance is 7m;if connect with 1M ohm resistor,detection distance is 5m

• R-CDS Internal VCC parallel connect with internal 1M ohm resistor to CDS pin (that is 196 9-pin) by R-CDS ,CDS connects with photoresistor,you can close detection function at night

Pin Definition:

• 3V3:3V3 power output

• GND:ground

• OUT:control output;when detect moving objects,it will output high level

• VIN:input voltage,4-28V

• CDS:enable control chip,lower than 0.7V,OUT will output low level all the time