Your Cart

RCWL-0516 Microwave Radar Sensor

RCWL-0516 Microwave Radar Sensor
RCWL-0516 Microwave Radar Sensor
RCWL-0516 Microwave Radar Sensor
RCWL-0516 Microwave Radar Sensor
RCWL-0516 Microwave Radar Sensor
GST Invoice
GST Invoice for Input Tax Credit.
Bulk Order
If your required quantity is more than listed below or for Bulk Orders/Quotes, please ping us for lead times & to pre-order.
Rs. 95.00
  • Stock: 3
  • Model: RCWL-0516-Microwave-Radar-Sensor
  • SKU: PL-1001

This is a mini radar motion sensor module is equipped with RCWL-9196 chip based on the doppler microwave induction technology.

Product Details:

  • Detection Distance    5-9m

  • Transmitting Power    20mW (typical); 30mW (max)

  • Storage Temperature    -40~100 celsius

  • Output Voltage Driving Capacity    100mA

  • Output Voltage    3.2-3.4V

  • Output Control Low Level    0V

  • Output Control High Level    3.3V

  • Operating Voltage    4-28V

  • Operating Temperature    20~80 celsius

  • Operating Current    2.8mA (typical); 3mA (max)


  • Equipped with RCWL-9196 chip supporting 4-28V wide voltage input, high level signal output when detecting the motion with active repeat trigger

  • 360 degree no blind angle detection with 5-7m deteciting distance, the detection not affected by the surroundings, better performance than the IR sensor

  • Support night detecting function turn on /off, adjustable repeat trigger time and detecting distance by add the SMD components to the corresponding pins

  • Working Voltage: DC 4-28V, Board Size: 35.9 X 17.3mm/1.41 X 0.68inch


  • Operating Voltage: 4-28V

  • Operating Current: 2.8mA (typical); 3mA (max)

  • Detection Distance: 5-9m

  • Transmitting Power: 20mW (typical); 30mW (max)

  • Output Voltage: 3.2-3.4V

  • Output Voltage Driving Capacity: 100mA

  • Trigger Way: repeat trigger

  • Output Control Low Level: 0V

  • Output Control High Level: 3.3V

  • Operating Temperature: -20~80 celsius

  • Storage Temperature: -40~100 celsius

Adjustment Part Introduction:

  • C-TM Adjust repeat trigger time,default trigger time is 2s;increasing capacitor's capacity will make repeat trigger time longer;and actual counting trigger time can operate as below: Stick capacitor on C-TM,test 9196 3-pin frequency F,repeat trigger time T=(1/f)*32768

  • R-GN Detection distance adjustment;connect with resistor and detection distance will become shorter;if not connect,detection distance is 7m;if connect with 1M ohm resistor,detection distance is 5m

  • R-CDS Internal VCC parallel connect with internal 1M ohm resistor to CDS pin (that is 196 9-pin) by R-CDS ,CDS connects with photoresistor,you can close detection function at night

Pin Definition:

  • 3V3:3V3 power output

  • GND:ground

  • OUT:control output;when detect moving objects,it will output high level

  • VIN:input voltage,4-28V

  • CDS:enable control chip,lower than 0.7V,OUT will output low level all the time

Write a review

Note: HTML is not translated!
Bad Good