Blue 16x2 Chars LCD Display widely used character displays. Extremely easy to use with all of the major microcontrollers.
You should have seen it on hobbyist as well as industrial projects As the name says it can display 16 characters on 1 line. There are 2 lines, which can be used to display ..
The 9V Battery Snap Connector with Power Plug is provides the ability to conveniently use a 9V battery to power many common boards and modules.
such as the popular Arduino and compatible microcontrollers. This plug is a very common barrel type with an outside diameter of 5.5mm and an inside diamete..
Dimensions : 79.5 x 64.5 x 21 mm.
Material: A grade acrylic sheet.
For Arduino UNO R3 Development Board only.
With screw copper pillar and installation instructions.
To protect your little computer against damages, dust and scratches Clear Top and Bottom.
This case provides easy..
Ethernet LAN Network Module For Arduino
Specifications:Chip board ENC28J60/SSThe board 25MHZ crystalThe network interface board HR911105A3.3 V power supply pinSize:5 x 2 x 1.5cm /1.92 x 0.72inchWeight: 11g..
L293D Arduino motor drive shield for Servo,Stepper And DC Motor
The shield contains two L293D motor drivers and one 74HC595 shift register.
The shift register expands 3 pins of the Arduino to 8 pins to control the direction for the motor drivers.
The output enable of the L293D ..
HC-SR505 Mini Infrared PIR Motion Sensor Infrared Detector Module is based on infrared technology, It automatically controls the products with high sensitivity, high reliability, ultra-small size, and ultra-low-voltage operation mode.
Piezo Electric sensor
A piezoelectric sensor/element is a device that uses the piezoelectric effect, it is basically a device which converts voltage to vibration and vibration to voltage. It normally comes in handy to measure knock (knock sensor) or vibration (vibration sensor).
Now a d..
This board listens to incoming sound through MIC. When it detects sound activity it generates output for a preset amount of time.
The output duration of the high signal can be adjusted by user using the onboard potentiometer. This output can be given to microcontroller directly. During silence ther..